–1 bar … 100 bar, 40 bar (with SICK T-connector DN15, DN25), 25 bar (with SICK T-connector DN40), 20 bar (with SICK T-connector DN50)
Communication interface
IO-Link, IO-Link V1.1, COM3 (230.4 kbit/s)
Temperature measurement
✔
Indication
✔ OLED + 3 status LEDs
Performance
Inlet zone
5 x DN
Output zone
3 x DN
Measurement accuracy
± 7 % From measured value + 2% of measuring range end value
Repeatability
< 1 cm/s
Resolution
0.01 m/s Speed; 0.1 L/min volume; 0.1% relative (via IO-Link)
Temperature drift
< 0.5 cm / (s*K)
Response time
< 2.5 s
Temperature measurement
Measurement accuracy (temperature)
± 1 °C
Resolution (Temperature)
< 0.1 °C
Response time (temperature)
< 5 s
Operating mode
Relative speed (%), Volume flow and total volume, Relative teach (%)
Electronics
Supply voltage
9 V DC … 30 V DC
Power consumption
< 2 W at 24 V DC (without load on the outputs)
< 8 W At maximum load
Initialization time
≤ 5 s
≤ 10 s (IO-Link)
Protection class
III
Connection type
M12 round connector x 1, 4-pin
Output signal
2 push-pull digital outputs (Q1 configurable for IO-Link; Q2 configurable as analog output (4 … 20 mA) / pulse output / digital input) for flow and temperature
Output current
< 100 mA
Output load
4 mA … 20 mA, max. 350 Ohm, if Uv < 12 V, 500 Ohm if Uv> 12 V
Lower signal level
3.5 mA … 3.8 mA
Upper signal level
20.5 mA … 21.5 mA
Inaccuracy
QA Pin2: < 0.5% full-range (20 mA)
Inductive load
1 H
Capacitive load
100 nF (2.5 nF, IO-Link mode)
EMC
EN 61326-1, EN 61326-2-3
Digital input limit
HIGH voltage dependent on Uv
LOW voltage < 4.0 V
MTTF
> 200 years
Mechanics
Process connection
Permanently installed clamping ring (only in conjunction with SICK T-connectors)